Re: High speed cd-rom's.

> Now that I've got your attention...... I have a 7 disk changer operating with
> the BBS, I also have an internal CD-ROm that I would like to include in the
> system, but I can't get the single to load, either before the 7 disk changer,
> or before. Is there a secret to this madness?

I"m running 2 internals and 2 Pioneer 6 pack changers. Check your
autoexec.bat to make sure you are specifying all devices. Here's my
autoexec.bat line that loads MSCDEX. You have to specify each device name.
Since my 2 changers are chained together on the SCSI bus, they require only
one designation:

C:\QEMM\LOADHI /R:1 C:\DOS\MSCDEX.EXE /D:MSCD001 /D:MSCD002 /D:MSCD003 /E /M:0 /L:J /V



Then the config.sys for the different drives:

DEVICE=C:\PIONEER\DRD60ASP.SYS /D:MSCD002 /S:0,1 /N:6,6 /C:CDP
DEVICE=C:\DEV\CDMKE.SYS /D:MSCD003 /P:300 /Q
DEVICE=C:\DEV\MTMCDS.SYS /D:MSCD001 /P:380 /A:0 /M:10

These lines load the device drivers for the Pioneer and the Mistsumi and
Panasonic drives. Note the MSCDXXX specifies the device names. The lower
number will be your first drive letter.

Hope this helps!
Dan

ڿ ��Ŀ � ���Ŀ ڿ ڿ     �¿ �   INDY * X..........A DreamWare Support Board
ô ô � � ô  � ���Ŵ >�< ����    Speedway, Indiana * (317)328-9398/297-2260
�� �� ��� ����� ����     � ���      33.6K USR/DS  14 CD-ROM drives online!