Re: Netting Automaticly

> > Here an update to my previous post on this, which will toss your mail packe
> > Create batch file as follows:
> > Vnet node# /dial2 /networdid=1
> > vme /toss
> > Change node# to whichever node to dial out on.
> > Change the number after /dial to your server number
> > Change the number after /networkid to the network your calling.
> > Eugene
> I tried to do this but all I got was the following:
> DSZLOG=
> DSZLOG environment variable not set.
> ?????????
> Thanks

You really should have the DSZLOG set in the enviroment
but if not use this batch file below.

This is the batch file I use for netting my VNET clients & picking
up my subs on those nets where I am a client.


C:\VBBS\VNETDIAL.BAT
rem set variable for dszlog
rem set DSZLOG=C:\VBBS\DSZ1.LOG
rem force an update (never needed but just to be safe)
rem I would remove these rem statements to suit if I
rem were you (left in so you'll know)
vnet 1 /u
vnet 1 /dial1 /networkid=87
vnet 1 /dial1205025 /networkid=1
vnet 1 /dial1205025 /networkid=50
vnet 1 /dial1205030 /networkid=1
vnet 1 /dial1205032 /networkid=1
rem set variable for dszlog (clear it now)
rem set DSZLOG=

Unless I plan to be away I don't automate the server (in CA)
dial out, I like to insure there is a clean connection so I
watch while I manually do that.


Hope this helps...

 Mike Cothran -=SysOp=- POG BBS 205-650-0998

   �ķ     ���      ��  �ķ     �    � �  Huntsville Computer Club, Inc. 
   �Ľ �ķ  �   �ķ ��  � � �ķ �  �Ķ �  Huntsville, Al.  205-650-0998  
   �   �Ľ  �   �Ľ �   �ļ �Ľ �� �Ľ �  VBBS 6.14b VirtualNet 1205020