Hi all,

Every single time I start VADV/OS2 up it gives me the following error:

SYS3175: A program in this session encountered a problem and
││
cannot continue.                                    │
    ││
│                                                   │
          ││
EXPLANATION: An access violation exception occurred and was generated
││
when an attempt was made either to load or store data in an
inaccessible──────┘│
location or to execute an inaccessible instruction.  This exception
│
corresponds to both the Intel 80386 processor general protection
fault─────────┘
(#13), caused by an invalid access attempt, and the page fault (#14),
caused by an attempt to access an uncommitted page or a page with
incorrect attributes for the desired operation.

ACTION: If you purchased this program, contact the supplier of the
program.  If you are the developer of this program, refer to the
information in the register.

------------

I've run the configuration check in VCONFIG and everything passes and I've
verified channel 1 is pointing to the correct COM port.  This is on OS/2 Warp
4.52 CP2

Thanks


--
[AT2k] -- Your VBBS/VADV Support Center -- [www.at2k.org] -- [bbs.at2k.org]