> I'm using FTP but argus and irex work fine as well. QWK networking with VADV
> flawed since it doesn't make REP packets. You'd have to use a conversion
> utility to convert the QWK packet it does create into a REP packet.
>
> > I tried to set my nodes from 1 node, to two nodes and after exiting the men
> > and then running the reset nodes it still shows as one node on the screen,
> > went back into the wait screen config and it showed 1 node again. Any idea
> > that? Does it have to be registered before you can add nodes?
>
> The unregistered version is limited to one node. After you copy the
> registration file from the above archive, it will let you have up to 10 nodes
>
> Steve
>
>
> --
> [AT2k] -- Your VBBS/VADV Support Center -- [www.at2k.org] -- [bbs.at2k.org]

I never could get any of the QWK to REP converters to work, so if someone
figures out one that works, please let me know.

VQWK is on my list of �Why Roland, did you code it this way.�


--
[AT2k] -- Your VBBS/VADV Support Center -- [www.at2k.org] -- [bbs.at2k.org]