Re: How to!

> Hello all
>
> Ok, couple of questions.
>
> One how do you register the software, too bad I can't find Roland I could get
> my old number from him. But anyway how do I go about it today?

Roland isn't taking registrations anymore. You can get registration files from
ftp://ftp.at2k.org/pub/register/vbbskey1.zip

> Two, what do most of you use for fidonet, irex or argus,,,,, so on and so on.
> Also, what about QWK is it like SBBS set up internal to handle the packing
> and sending?

I'm using FTP but argus and irex work fine as well. QWK networking with VADV is
flawed since it doesn't make REP packets. You'd have to use a conversion
utility to convert the QWK packet it does create into a REP packet.

> I tried to set my nodes from 1 node, to two nodes and after exiting the menu
> and then running the reset nodes it still shows as one node on the screen, I
> went back into the wait screen config and it showed 1 node again. Any idea on
> that? Does it have to be registered before you can add nodes?

The unregistered version is limited to one node. After you copy the
registration file from the above archive, it will let you have up to 10 nodes.

Steve


--
[AT2k] -- Your VBBS/VADV Support Center -- [www.at2k.org] -- [bbs.at2k.org]